Gantt Branch Rollup enable for Table View

We use table view extensively - it would be great to have the roll up feature (item & branch) currently enabled only in Gantt view enabled in Table view, as it applies to the project as a whole, not just a single view source. Also, you have to actively go into Gantt to refresh the roll up when you make changes to have them show in table view. Is there a way to have that update automatically?

Effort doesn't seem to roll up - only as an aggregation sum which is hard to read, if it could sum the full hours for child tasks that would be more useful. 

thanks! 

Upvote 0
👍 Spot On 💡 Innovative Approach 💪 Stellar Advice ✅ Solved 🪄 Remove Kudos
Комментариев: 3

Thank you for the detailed feedback Kate Russell, I'm passing it on to the team now 👍

Lisa Community Team at Wrike Wrike Product Manager Become a Wrike expert with Wrike Discover

Lisa Wrike Team member Become a Wrike expert with Wrike Discover

0
👍 Spot On 💡 Innovative Approach 💪 Stellar Advice ✅ Solved 🪄 Remove Kudos

We have a lot of blueprint development going on, and it's really annoying to update the Gantt, but have to force the roll-up over and over again.  Also, once the blueprint is used, a similar situation happens forcing users to have to go back to table view to get the roll-up to update.

0
👍 Spot On 💡 Innovative Approach 💪 Stellar Advice ✅ Solved 🪄 Remove Kudos
Avatar
Cansu

Thank you for taking the time to share your thoughts about the Gantt view Richard Herzog, I've made aware our Product team of your feedback 👍🏼

0
👍 Spot On 💡 Innovative Approach 💪 Stellar Advice ✅ Solved 🪄 Remove Kudos

Folllowing List for Post: Gantt Branch Rollup enable for Table View
[this list is visible for admins and agents only]

Вверх
Didn’t find what you were looking for? Write new post